6 articles Found
-
Haltech ECU Setup for Coyote Swaps: OEM Sensors vs Standalone Conversion
Haltech ECU setup for Coyote swaps: native Ford sensors vs standalone conversion, wiring differences, and key considerations for non-Ford chassis. -
Crank and Cam Timing Sensors: Reluctor Ring Selection for LS, LT, and Coyote Swaps
Crank and cam timing sensors reluctor ring selection for LS, LT, and Coyote engines. Covers OEM vs billet rings, sensor types, and ECU configuration.
-
Haltech Harness Wiring: Gauge, Shielding, Standards
A practical guide to Haltech harness wiring: wire gauge selection, when to use shielded cable, Deutsch and Tyco connector standards, and pre-start checks. -
Oxygen Sensor Placement for Engine Swaps
Wideband oxygen sensor placement guide for engine swap builds. Pre-cat vs post-cat strategy, sensor types, Haltech wiring tips, and common mistakes to avoid. -
Haltech ECU for Engine Swaps: Complete Builder's Guide
Haltech ECU for engine swaps. This guide covers ECU selection for LS, LT, Coyote, and small-block Ford builds, plus essential sensors you need. -
LS Swap ECU Tuning Guide: DIY vs. Dyno
Tuning LS swap fuel injection doesn't have to cost a fortune. This guide covers ECU options, DIY tuning limits, when to use a dyno, and the mistakes to avoid.
