Meilleurs articles
-
LS1 vs LS2 vs LS3 vs LS7: Choosing the Right LS Engine Generation for Your Swap
Picking the right LS engine generation for swap projects is where a lot of builds go sideways before the engine is even on the stand. Not because the buyer chose a bad engine, but because they chose the wrong one for their chassis, their ECU budget, or the power level they actually want to run. The LS family is broad. LS1, LS2, LS3, LS7, and the later LT-series engines all share a family resemblance but differ in ways that matter the moment you start sourcing mounts, wiring looms, and accessory brackets.
-
Holley Sniper 2 EFI: Complete Integration Guide for Engine Swaps
Holley Sniper 2 EFI installation guide covering PDM wiring, CAN bus setup, touchscreen configuration, fuel system, and cold-start commissioning.
1 articles trouvés
-
Oxygen Sensor Placement for Engine Swaps
Wideband oxygen sensor placement guide for engine swap builds. Pre-cat vs post-cat strategy, sensor types, Haltech wiring tips, and common mistakes to avoid.
